Furnace Installation Process & 2025–2026 Price Guide for Follansbee, WV

Quick Answer

In Follansbee, WV, new furnace installation costs typically range from $2,635 to $5,610, including labor, permits, and full commissioning.

Furnace installations near the Ohio River demand extra attention to moisture control, airflow balance, and corrosion prevention. If your installer doesn’t mention load calculations, humidity testing, or permit filing, that’s a red flag.

How long does furnace installation take?

Most installations in Follansbee are completed in 4–8 hours, depending on your home’s layout and humidity control requirements.

What’s included in the installation cost?

Every Honest Fix installation includes labor, permits, humidity and airflow testing, commissioning, and a first-year maintenance tune-up backed by our Lifetime Trust Shield guarantee.

A Follansbee Homeowner’s Story

A homeowner near Main Street reached out after noticing rust forming on her furnace cabinet and vents. Her home sat close to the river, and the older venting system wasn’t sealed properly — pulling in damp outside air.

Our inspection confirmed moisture intrusion and early corrosion on internal components. We installed a sealed-combustion high-efficiency furnace with corrosion-resistant venting and dehumidification support. After commissioning, her home stayed warmer, drier, and safer.

In Follansbee, the right installation protects your comfort — and your equipment.

Why Installation Quality Matters in Follansbee

Riverfront homes and humid basements make Follansbee a unique HVAC environment. Moisture, corrosion, and fluctuating airflow can quietly shorten furnace life. Proper design and commissioning prevent these issues before they start.

At Honest Fix, every installation includes:

• Manual J Load Calculation: Ensures the furnace is neither oversized nor undersized for your home.
• Humidity & Airflow Testing: Detects excess moisture or restricted ducts that cause rust and uneven heat.
• Sealed Venting Systems: Protect against condensation and corrosion common near the river.
• Permit Filing & Code Compliance: Managed directly with Brooke County for peace of mind.

When your installation is engineered for both airflow and humidity, comfort lasts longer — and so does your furnace.

Furnace Installation Costs in Follansbee (2025–2026)

Most homeowners in Follansbee spend $2,635 to $5,610 for a complete furnace installation, including all labor, permits, and testing.

Cost factors:

• Efficiency Rating (AFUE): 95–98% models offer lower fuel use and quieter operation.
• Humidity Protection: Sealed venting or whole-home dehumidification may add a small cost but prevent future corrosion.
• Accessibility: Older basements or tight spaces add setup time.
• Airflow Adjustments: Necessary in multi-level or riverfront homes with high humidity.

Your Honest Fix quote includes every part of the job — load calculation, commissioning, and final testing — never “bare minimum” pricing.

Step-by-Step: The Furnace Installation Process

1. Pre-Installation Assessment

We start by inspecting ducts, gas lines, and moisture levels. A Manual J load calculation determines the correct furnace capacity for your home’s insulation and layout.

2. Safe System Removal

We disconnect the old system, protect flooring, and safely remove venting and condensate lines. If rust or corrosion is found, we replace affected parts and seal connections.

3. Furnace Setup & Moisture Protection

Your new furnace is placed level on vibration pads and sealed to ductwork. For river-adjacent homes, we install sealed-combustion systems that draw air from outside instead of damp basements.

4. Airflow & Humidity Balancing

Our technicians test static pressure and humidity levels. We adjust duct dampers and recommend humidity control solutions if levels exceed safe ranges.

5. System Commissioning

We verify:

• Temperature rise and airflow balance
• Combustion and CO safety
• Gas and electrical readings
• Condensate drainage and vent sealing
• Humidity and corrosion protection checks

You’ll receive documented performance readings before we leave.

6. Homeowner Orientation

We review thermostat settings, humidity controls, and your Lifetime Trust Shield coverage. You’ll also receive your commissioning report and maintenance plan.

Red Flags for Follansbee Homeowners

• “You don’t need to worry about humidity.”
• No mention of vent sealing or moisture testing.
• “We can skip the permit — it’s just a swap.”
• No commissioning or post-installation report.

Moisture and shortcuts don’t mix — especially near the river.

Repair Costs vs. Replacement

Typical repair costs in Follansbee:

• Minor repairs: $145 – $550
• Major components: $480 – $2,200+

If you’re seeing corrosion, rust, or repeat gas-ignition failures, those are signs your system’s efficiency has been compromised. A new, sealed-combustion system pays for itself in safety, reliability, and comfort.

Your Honest Fix Guarantees

Every installation in Follansbee is backed by our Lifetime Trust Shield, which includes:

• Lifetime Labor Warranty (15 Years): Covers all installation-related labor for 15 years when yearly maintenance is performed by Honest Fix.
• 90-Day Money-Back Guarantee: If you’re not completely satisfied, we’ll make it right or refund your installation cost.
• No-Lemon Replacement: If your new furnace requires three or more major repairs in the first year, we replace it.
• Energy Savings Guarantee: 15% minimum energy-use reduction, or we refund up to 10% of your installation cost.
• Free First-Year Tune-Up: Ensures your system maintains verified efficiency and comfort.

For service or repair work, our Service Trust Guardian includes:

• 5-Year Labor Warranty on repairs
• No overtime rates
• $50 on-time arrival credit

These guarantees are the foundation of how we earn customer trust across the Ohio Valley.

Frequently Asked Questions

Do I need a permit for furnace replacement in Follansbee?

Yes. Brooke County requires mechanical permits for full system replacements. Honest Fix handles all permit filing and inspections.

What’s special about sealed-combustion furnaces?

They pull air from outside the home rather than the basement, reducing corrosion risk and improving safety — ideal for river-adjacent homes.

How long does installation take?

Usually 4–8 hours, depending on vent and humidity conditions.

What guarantees do you offer?

All installations include our Lifetime Trust Shield (15-Year Labor Warranty) and Energy Savings Guarantee.

The Honest Fix Difference

Follansbee homes face more humidity and temperature swings than most. We install furnaces designed to handle both. Every installation includes airflow and moisture testing, sealed venting, and performance documentation — all backed by transparent, written guarantees.

Learn about our guarantees before you decide.